13mm impact drill 1100W 1200/3200rpm 220V 2-speed

Drilling in various types of steel, plastic, wood and masonry using various drills and accessories.

• Maximum RPM: Gear 1 = 0-1200 and Gear 2 = 0-3200
  
• Gear 1 Low: 850 RPM
  
• Gear 1 Medium: 1050RPM
  
• Gear 1 Max: 1275 RPM
  
• Gear 2 Low: 2600 RPM
  
• Gear 2 Medium: 2900RPM
  
• Gear 2 Max: 3200 RPM
  
• Maximum chuck capacity: 13 mm (keyed)
  
• Drilling capacity: wood 23mm, steel 13mm and masonry 13mm
  
• Maximum Impact Rate: Gear 1 = 0-19200 and Gear 2 = 0-44800 BPM
  
• Power: 1100W
  
• Voltage: 220-240 (50 Hz)
  
• Modes: Drill and Hammer
  
• Variable speed control selector
  
• Trigger lock on button

Included accessories

• Hammer drill
  
• Chuck key
  
• Depth limiting rod
  
• Auxiliary handle
  

Installing Accessory Bits

Use the provided chuck key to lock/unlock. Rotate the chuck counterclockwise until the chuck opening is large enough to accommodate the accessory. Insert the accessory into the chuck. Turn the ring clockwise until the tool is firmly secured. Use the chuck key to properly lock the chuck.

Installing the auxiliary handle

To assemble the auxiliary cable, loosen the cable screw by turning the plastic part counterclockwise. Mount the handle over the chuck collar until it is flush with the flat surface on the front of the drill. Rotate the plastic part of the handle clockwise to secure it in place.

Trigger lock

To lock the trigger, press the lock button located on the side of the handle with one hand, while the other hand presses the trigger.

Rotation Setting

Reverse: To select reverse rotation, push the lever to the right side of the drill. Forward: To select forward rotation, release the on/off button and push the lever to the left side of the tool.

Gear selection

Turn the gear selector switch to gear 1 or gear 2 depending on the desired speed and application.

Specifications